污水處理設備 污泥處理設備 水處理過濾器 軟化水設備/除鹽設備 純凈水設備 消毒設備|加藥設備 供水/儲水/集水/排水/輔助 水處理膜 過濾器濾芯 水處理濾料 水處理劑 水處理填料 其它水處理設備
河南英科傳感技術有限公司
參 考 價 | 面議 |
產品型號
品 牌
廠商性質其他
所 在 地鄭州市
聯系方式:查看聯系方式
更新時間:2025-07-17 09:47:14瀏覽次數:15次
聯系我時,請告知來自 環保在線Introduction:The R-4OX is a 32mm industrial Oxygen sensor, ideal for fixed gas detectors. Key Features: robust design, proven reliability and high performance
Introduction:The R-4OX is a 32mm industrial Oxygen sensor, ideal for fixed gas detectors.
Key Features: robust design, proven reliability and high performance
Erformance Characteristics
Output signal | 0.10 ± 0.03 mA |
Zero Current (Offset) | < 0.6% vol. O2 |
T90 Response Time | < 15 seconds |
Measurement Range | 0 - 25% Oxygen |
Maximum Overload | 30% Oxygen |
Linearity | Linear |
Recommended Load Resistor | 100 ohms |
Environmental Details
Temperature Range Continuous | -30℃to +50℃ |
Pressure Range | 800 to 1200 mbar |
Operating Humidity Range | 5% to 95% RH |
Important Note:
All performance data is based on conditions at 20℃, 50%RH and 1 atm, using CCR Scientific recommended circuitry.
Sensor performance is temperature dependent, and please contact CCR Scientific for temperature performance other than 20℃.
Lifetime Details
Long Term Output Drift | < 5% per annum |
Recommended Storage Temp | 0℃to 20℃ |
Expected Operating Life | > 24 months in air |
Standard Warranty | 24 months from date of dispatch |
Intrinsic Safety Data
Maximum current in normal operation (pure O2) | 0.01 A |
Maximum o/c Voltage (10 to 99% O2) | 0.9 V |
Maximum s/c Current (10 to 99% O2) | 0.5 A |
Toxic gases at TLV levels will have no cross-sensitivity effect on CCR-Scientific oxygen sensors. At very high levels (i.e. percent levels), highly oxidising gases (e.g. ozone, chlorine) will interfere to the extent of their oxygen equivalent, but most other commonly occurring gases will have no effect.
Acid Gases
IMPORTANT NOTE: Acid gases such as CO2 and SO2 will be absorbed by the electrolyte and tend to increase the flux of oxygen to the electrode. This gives an enhanced oxygen signal of approximately 0.3% of signal per 1% CO2. CCR Scientific oxygen sensors are not suitable for continuous operation in concentrations of CO2 above 25%.
您感興趣的產品PRODUCTS YOU ARE INTERESTED IN
環保在線 設計制作,未經允許翻錄必究 .? ? ?
請輸入賬號
請輸入密碼
請輸驗證碼
請輸入你感興趣的產品
請簡單描述您的需求
請選擇省份
聯系方式
河南英科傳感技術有限公司