Different anti-corrosion type magnetic level gauge and basic type magnetic level gauge is necessary, including different materials, anti-corrosion type magnetic level gauge is stainless steel liner PTFE, and because the material special so the price to gauge the price more expensive than ordinary magnetic level more, important is the technology on processing. Stainless steel liner PTFE technology is very important, the key in the process of lining PTFE is often some of the details of technology. However, in use can be obvious, anti-corrosion so-called medium sure it measured not in general, for example: hydrochloric acid, sulfuric acid, hydrofluoric acid, these are chemical liquid is very dangerous, if your level meter leaks and other reasons will bring great trouble and harm. Only select anti-corrosion type magnetic high quality level gauge can be used at rest, so the user in the selection of anti-corrosion type magnetic level timing don't way cheaper prices, with some inferior products, if appear problem losses must be larger than you want!
Through summarizing the anti-corrosion type magnetic level gauge at the vast number of users of the products have the clear understanding!
Magnetic level gauge is installed should first by adjusting the magnetic turning plate moved slowly along the surface of the turning plate, all the red side toward the observer. Liquid level gauge to run before, should first open the valve, and then slowly open the valve, the medium slowly into the cylinder, let the flap by tracking instructions. And the adjusting screw to adjust zero level. In use process, individual flap failure caused by liquid level change suddenly or other reasons, . can adjust magnetic correction. In the pressure test of the container before, please close the communicating valve and liquid level gauge. The magnetic turning plate level gauge after long-term use, the inside of the body if the medium precipitates, will affect the float normal work, must be regularly cleaned. Cleaning before the first turn off the gas-liquid valve, remove the remaining material cylinder. After cleaning in the original assembly, float cut suddenly reversed, gasket should be replaced to prevent aging leakage, tighten the screws. Anticorrosion type magnetic level gauge stainless steel body with polypropylene PP process, has the very high structural strength and corrosion resistance, and can be applied to hydrochloric acid, alkaline liquid and many organic solvents （especially active aliphatic solvent）. Measurement but not suitable for concentrated nitric acid, MOET acid mixture, chlorinated solvents, aliphatic, aromatic hydrogen medium liquid. Suitable for measuring the corrosive medium. In addition to the instructions can be equipped with remote transmitter, alarm （switch）, detection function. Instructions novel, intuitive readings, eye-catching, observe the direction of the indicator can be based on user needs to change the angle. Large measuring range, without tank height limit, indicating mechanism and the measured medium is compley isolated, and good sealing performance, high reliability, safety. Simple structure, convenient installation, low maintenance cost.
